How To Set Up Packing Tape Dispenser

Download Article

Tape dispensers make packaging boxes easy and efficient. It'south of import to learn how to properly utilise a record dispenser because shipping companies will send back packages that are not taped well. It can be a fleck catchy to load tape into a dispenser, but once everything is prepare the dispenser will save you tons of fourth dimension!

1
Locate the end of your scroll of tape. If you're loading a new roll, the finish should be clearly marked. If you're working with a used roll, run a fingernail around the tape to experience for where the cease is. Pull 0.25–0.5 inches (0.64–1.27 cm) of tape and fold it back on the roll.^[1]
- Folding the tape back on itself simulates what the cease of a new coil of tape looks like.
2
Slide the tape onto the spindle with the sticky side facing down. The tape dispenser handle should be to your right and the non-adhesive side of the tape must be facing upward. Take the finish of the tape curl facing the roller and cutting blade.
- If you're having trouble putting the roll of tape on the spindle, lay the dispenser down on a flat, stable surface to make things easier.
Advertisement
3
Thread the end of the record roll betwixt the roller and guide. At that place is a small slot in betwixt the dispenser roller and the metallic or plastic guide. To requite yourself plenty of room to thread the record through, concord the guide open by pressing down on the tab just below it.^[ii]
- Remember to check if the sticky part of the tape is facing down. If it's not, it will stick to the dispenser roller.
4
Pull the tape up so that it goes over the serrated blade. To avert cut yourself on the blade, pull the tape 1–2 inches (ii.5–5.1 cm) above it. And then, pull the tape dorsum against the cutting edge to make a neat, even cut.^[three]
- Throw away the record that gets cut off by the bract.
Advertisement

ane
Examination the dispenser's tension by rolling a minor amount of tape out. Use an old box for this trial run. Cut the record with the serrated blade later rolling out about 5 inches (xiii cm) of it. You are looking to see if the tape unwinds smoothly and sticks to the box correctly.^[iv]
- Do not test your dispenser on packages you lot desire to tape up. Wait until you know the dispenser is properly loaded and adjusted before you start working with it for real.
2
Tighten the nut on the spindle clockwise to increase the tension. The nut is in the middle of the spindle and lets you adjust the tension of the dispenser. If the tension is also loose, the tape might not wrap tightly enough around the packaging to seal information technology properly.^[5]
- If the spindle is likewise loose, you could end upwards using more than tape than you had in mind.
3
Loosen the nut counterclockwise to decrease the tension. If you lot find yourself pulling really hard to coil the tape out, it might be because the spindle is likewise tight. If there is too much tension, the tape will not curlicue evenly over your packaging or attach to the box the style you want it to.^[six]
- Keep tightening and loosening the nut until you tin smoothly curlicue out the record without using excessive force.
Advertisement

Inquire a Question

200 characters left

Include your email address to go a message when this question is answered.

Submit

Thanks for submitting a tip for review!

Nearly This Article

Thanks to all authors for creating a folio that has been read 52,055 times.

Did this article help yous?